top of page


The RIG-150 is advanced enough to have computer-controlled flow and temperature programming capabilities, but simple enough that all the computer skills needed are point-and-click. Design your experiments by merely typing the desired operating conditions into a computer panel that displays a model of the system. Then watch as the RIG-150 monitors and gathers temperature and thermal conductivity data. Later you can process this data using the ISRI Analysis software provided in the RIG-150 package.


The RIG-150 is able to provide this flexibility of use through its software, which lets you control and adapt the unit to suit your needs. For example, since catalytic experiments are usually conducted with different reactants, one panel of the software allows you to easily change the calibration of the gas flow controllers to adapt to new gases and mixtures. These new calibrations can then be stored for later use. Another software panel allows you enter experimental conditions for Temperature Programmed studies such as TPD or TPR, while another panel for adsorption type measurements allows you to enter any number and combination of gas pulses. Each of these panels is easy-to-read, user friendly, and accessible at the click of a button. Once an experiment has started, the TC and temperature signals are displayed on another panel and saved as ASCII data files for later analysis. Data collection measurements can be linked with the steady state experiments to provide users with a possibility of combining catalyst pretreatment with pulse and/or TPD/TPR studies in a single run.


The RIG-150 software controls the hardware inside the unit. Hardware includes:


  • High Temperature Furnace [Operating up to 900 °C]

  • Quartz Reactor with removable thermocouple well

  • Temperature Controlled Heated Lines for Liquid Feed Use

  • Easy to Install Quartz Saturator

  • Programmable Furnace Temperature Controller [Ramp & Soak up to 9 Steps]

  • Quartz BET Sample Holder with Adjustable Insulated Bath


Since safety is a primary concern at ISRI, the RIG-150's front panel has redundant front panel indicators - LED gas indicators, temperature and TC cell displays. A special "Filament Safe" circuit prevents damage of the TC cell filaments if the carrier gas flow is unexpectedly cut off.


If you need to use additional types of instrumention, such as gas chromatographs or mass spectrometers, the RIG-150 has two auxiliary outlet lines to easily interface with the necessary equipment. ISRI can provide you with gas chromatographs, mass spectrometers, integrators, and other state of the art analytical equipment at a substantial savings, complete with full service and warranty programs.


Of course, ISRI realizes that your needs may not be the same as everyone else's. As a small company, ISRI has the benefit of being able to adapt to your special research needs. If you have an option that you need on your RIG-150, whether hardware or software, ISRI can custom make a unit that meets your specifications.


RIG-150 Technical Specifications:


Operating Pressure


Construction Material

1/8" stainless steel tubing


quartz, flow-through

Sample loading

5 mg to 2 g on quartz frit

Sample loading for BET studies

10 mg to 2 g

Operating Temperature

Room to 900 °C

Gas Input Ports


Liquid Feed Line


Gas Flow Ranges

Specified by customer

Auxiliary Outlet Ports



TCD with temperature controller


45" ´ 21" ´ 26"


~250 lbs


Data Acquisition and Control System:


Both PC or Macintosh Available

Signal Range


Data Format


bottom of page